Power harvesting, energy harvesting, power scavenging, and energy scavenging are four terms commonly used to describe the process of extracting useful electrical energy from other ambient energy sources using special materials called transducers that have the ability to convert one form of energy into another.
While the words power and energy have vastly different definitions, the terms “power harvesting” and “energy harvesting” are used interchangeably throughout much of the literature to describe the same process of extracting electrical energy from ambient sources. Even though most of the energy coupling materials currently available have been around for decades, their use for the specific purpose of power harvesting has not been thoroughly examined until recently, when the power requirements of many electronic devices has reduced drastically.
The overall objective of this research is to typify the power source characteristics of various transducer devices in order to find some basic way to compare the relative energy densities of each type of device and, where possible, the comparative energy densities within subcategories of harvesting techniques. Included in this research is also a comparison of power storage techniques, which is often neglected in other literature sources.
An initial analysis of power storage devices explores the background of secondary (rechargeable) batteries and supercapacitors, the advantages and disadvantages of each, as well as the promising characteristics of recent supercapacitor technology developments. Also explored is research into the effectiveness of piezoelectric energy harvesting for the purpose of battery charging, with particular focus on the current output of piezoelectric harvesters.
The first objective involved presenting and verifying a model for a cantilever piezoelectric bimorph. Next, an investigation into new active fiber composite materials and macro fiber composite devices utilizing the d31 coefficient is performed in comparison to a monolithic piezoelectric bimorph. The information gathered here was used to design a two bimorph device termed the mobile energy harvester (MEH). Worn by a human being at the waste level, the MEH harvests energy from each footfall during walking or running.
The next objective involved characterizing small temperature gradient (less than 200 oC) thermoelectric generators (TEGs). Four TEGs were linked in series and joined with a specially made aluminum base and fin heat sink. This device was then mounted to the exhaust system of an automobile and proved capable of recharging both an 80 and a 300 milliamp-hour battery. A switching circuit concept to step up the output voltage is also presented.
However, the circuit proves somewhat difficult to implement, so an alternative DC/DC device is proposed as a possible solution. With the advent of highly efficient, low voltage DC to DC converters, it is shown that their high current, low voltage output can be converted to a higher voltage source that is suitable for many electronic and recharging applications.
As extensive literature exists on the capabilities of photovoltaic and electromagnetic energy harvesting, no original experimentation is presented. Instead, only a brief overview of the pertinent technological advances is provided in this document for the purpose of comparison to piezoelectric and thermoelectric energy harvesting.
Author: Justin R. Farmer
Source: Virginia Tech
>> 100+ Easy Electronics Projects for Engineering Students